In stock at JC Gilmore Pty Ltd

SupaBord temporary floor protection, available in Port Melbourne.

Breathable, 100% recycled and Australian owned. Stocked and supported locally at JC Gilmore Pty Ltd, Port Melbourne VIC.

206-208 Lorimer Street, Port Melbourne VIC 3207 03 9646 1222
JC Gilmore storefront at 206-208 Lorimer Street, Port Melbourne VIC

About the product

The floor protection that breathes.


For more than fifteen years SupaBord has protected floors on Australian job sites. It is the temporary floor protection that does the one thing imported plastic cannot. It breathes. Floors cure underneath instead of trapping moisture, which is the difference between a finished job and a callback. It is Australian owned, made from fully recycled material and recyclable after use, and every roll is pre marked with measurements and cut lines for a faster, cleaner fit.

How-to guides

Installing SupaBord, step by step.

Short guides your team and your customers can follow.

Built for any worksite — SupaBord how-to video
01

Built for any worksite

Spills and accidents, handled — SupaBord how-to video
02

Spills and accidents, handled

Laying it over carpet — SupaBord how-to video
03

Laying it over carpet

Laying it on hard floors — SupaBord how-to video
04

Laying it on hard floors

Buy locally

SupaBord at JC Gilmore Pty Ltd.

Gilmores has been an industry name for more than 35 years, supplying industrial packaging and office supplies Australia-wide. The Port Melbourne operation supports construction and other businesses with packaging and protective products, and is now part of UBEECO Packaging Solutions.

Store
JC Gilmore Pty Ltd
Address
206-208 Lorimer Street, Port Melbourne VIC 3207
Phone
03 9646 1222
Mon to Fri
7:30am - 4:30pm
Saturday
Closed
Sunday
Closed
Serving
Port Melbourne, South Melbourne, Fishermans Bend, Docklands, Southbank, Albert Park, Middle Park and surrounding Melbourne areas
Local
Industry name for 35+ years; at the Lorimer Street premises since 1999
Social
LinkedIn
JC Gilmore logo

Questions

SupaBord, answered.

Will it mark or stain my finished floor? +
No. SupaBord is breathable, so moisture escapes instead of being trapped against the surface, which is what causes marking and cupping under non breathable plastic. It is designed to sit on finished floors safely.
How long can I leave it down? +
Through a full fit out. Use Joint Tape to hold seams for up to 90 days and the Edge Tape to hold edges for up to 150 days, and it lifts away cleanly when the job is done.
Can you drive a trolley or scaffold over it? +
Yes. Contractor Grade is built for heavy site traffic, trolleys, scaffold and general construction impact and abrasion.
Is it waterproof? +
It resists spills and protects against water and debris while still letting the floor breathe underneath. It is water resistant protection, not a sealed plastic barrier, which is the point.
What surfaces can I use it on? +
Timber, tile, vinyl, concrete, stone, bench tops and stairs. It scores and folds easily, so it wraps edges and steps without bunching.
How is it better than the imported plastic rolls? +
It breathes, so no trapped moisture and no callbacks. It is Australian owned, made from recycled material and recyclable, and every roll is pre marked so it lays faster with less waste.
Where can I buy it near me? +
SupaBord is stocked at JC Gilmore Pty Ltd, 206-208 Lorimer Street, Port Melbourne VIC 3207. Call 03 9646 1222 to check stock or place an order.